destination packet
英 [ˌdestɪˈneɪʃn ˈpækɪt]
美 [ˌdestɪˈneɪʃn ˈpækɪt]
网络 目的包
双语例句
- Ethernet packet headers, including the Ethernet source and destination address, packet size and the Ethernet packet type.
Ethernet数据包头，包括Ethernet来源和目标地址，数据包大小和Ethernet数据包类型。 - Upon reaching the destination node the VLAN ID is removed from the packet by the adjacent switch and forwarded to the attached device.
到达目的地端所接的交换器时，这个含有VLAN编号的表头就会被拿掉，然后将封包传给目的地的设备。 - Different values of parameters in the models lead to different destination distributions and average distances between packet sources and destinations.
通过设置参数的值，可以控制模型中负载分布的均匀程度与源、目的节点之间的平均距离。 - When the chunks arrive at their final destination, IP assembles the pieces into the original packet.
当这些小数据包到达最终目的地时，IP协议又把这些数据块组装成原来的数据包。 - This paper addresses a problem of selecting a route for every pair of source/ destination nodes in a packet switched communication network in order to minimize the average delay encountered by messages.
本文研究分组交换通信网中每对源／目的结点的路由选择问题以使信息通过网络的平均时延最小。 - The destination node calculates the end-to-end packet delay, jitter, packet loss ratio periodically, and determines the network load conditions by metering the network parameters, then sends the results periodically to the source node.
通信过程中目的节点周期性计算数据包的端到端延时、抖动和丢包率，通过这些网络参数来判断网络负载状况，并将结果周期性的发送给源节点。 - The IP header includes the source IP address where the packet originates, destination IP address where the packet is going, the transport protocol initiating the request.
IP数据头包括数据包产生地的主机IP地址，数据包即将前往的目的地IP地址，以及发出请求的传输协议。 - LVS-NAT operates on a director server by grabbing incoming packets that are destined for configuration-specified ports and rewriting the destination address in the packet header dynamically.
LVS-NAT操作控制器服务器的方式是，获取发往特定配置的端口的引入包，并动态地在包的头部重写目的地址。 - The different between this agreement and other location-based routing protocol is that the choice of routing path is not dependent on the node, but to choose the best road to reach the destination node as data packet delivery routing path.
本协议与其它基于位置的路由协议的不同之处是，在路由路径的选择上不再是建立在节点之上，而是建立在选择最优的到达目的节点的哪些道路作为其数据包传递的路由路径。 - At the destination host, the packet is passed up to UDP and delivered to the destination port.
在目标主机，数据包被传递至UDP协议程序并送到目的地端口。